This article is a mirror article of machine translation, please click here to jump to the original article.

View: 2|Reply: 1

[Wireless Communication] iKuai (iKuai) sets wireless AP mode (bypass AP, bridge mode).

[Copy link]
Posted on9 minutes ago | | | |
Requirement: Purchased an iKuai IK-Q6000 device. Since the main router does not have WiFi functionality, iKuai acts as the main router's wireless function, and client IP addresses are assigned by the main router's DHCP service. That is, iKuai sets the wireless AP mode (bypass AP, bridge mode).

The default LAN management/gateway address for the iKuai IK-Q6000 is usually 192.168.9.1or192.168.1.1。 Use a network cable to connect the LAN port of the iKuai to the main router's LAN port.

Turn off the iFast DHCP service

Network Settings -> DHCP Settings -> DHCP Server, as shown below:



Set the LAN port IP address

Manually set the IP address of the iKuai LAN port (if not set, the iKuai LAN port remains the default IP and is not on the same subnet as the main router, you will not be able to access the iKuai web management interface). If you only disable DHCP but have not changed the default LAN port IP (the default for iKuai hardware routers/APs is usually 192.168.9.1), and the main router assigns the device an IP to another subnet (e.g., 192.168.31.x), the device cannot directly open the iKuai backend due to cross-subnet.

Network Settings -> Internal and external network settings, manual settings as follows:



Static routing configuration

Although devices connected to the iKuai router via WiFi can access the internet, the iKuai device cannot access the internet, causing firmware updates to fail and requiring static routing setup.

Go to Network Settings -> Static Routes, click Add, and fill in the following parameters:

• Line: Select lan1 (the internal port where you modified the IP).
• Destination address: Enter 0.0.0.0 (representing all external network traffic).
• Subnet mask: enter 0.0.0.0.
• Gateway: Enter the IP address of the main route, i.e., 192.168.31.1.
• Priority: Keep the default (e.g., 1).

As shown below:





Previous:.NET/C# Based on SQL SERVER, uses MERGE + HOLDLOCK for high-concurrency identifiers
 Landlord| Posted on25 seconds ago |
After manually setting the IP address on AiKuai, the routerOS cannot be viewed in the DHCP server's Leases.

When clients manually configure static IPs, no DHCP requests (Discover/Request) are sent, so RouterOS's DHCP Server Leases list naturally does not record these devices.

All LAN devices communicating with the router leave MAC-IP mapping records, which is the most direct way to view static IP devices:

WinBox / WebFig path: Go to IP -> ARP from the left menu. The command is as follows:

Manually enter MAC bindings

1. Go to IP -> DHCP Server -> Leases and click +(Add).
2. Fill in the target device's Address (specified IP), MAC Address (physical address of the device's network card), and the corresponding server.
Disclaimer:
All software, programming materials or articles published by Code Farmer Network are only for learning and research purposes; The above content shall not be used for commercial or illegal purposes, otherwise, users shall bear all consequences. The information on this site comes from the Internet, and copyright disputes have nothing to do with this site. You must completely delete the above content from your computer within 24 hours of downloading. If you like the program, please support genuine software, purchase registration, and get better genuine services. If there is any infringement, please contact us by email.

Mail To:help@itsvse.com